OVERVIEW - Custom install ci1017 8-Way Network Lan Mapper for Nerwork & Phone Cable:
The CI1017 consists of the master unit and eight remote identifiers. The IDs are marked on the identifiers. This device is used to test LAN cable with RJ45 connector and PHONE cable with RJ11 connector. The device is connected to one end of the testing cable and the remote identifiers are connected to the other end of the testing cables. There are four faults that can be tested on each pair: Overvoltage, Open, Short, Reversed pair. By analysis, test results for each pair can help find more faults such as: Crossed pair, Split pair, Transposed pair, and Double split pair. To put tone on a cable, simply push and hold down the "TEST" button until the "TONE" LED lights. The device is now transmitting tone on the cable. The "TONE" LED will flash indicating that the tone mode is on. Tone mode will automatically shut off after approximately 30 minutes. To exit the tone mode, push the "TEST" button once. The "TONE" LED will turn off.
SPECIFICATIONS - CUSTOM INSTALL CI1017 8-WAY NETWORK LAN MAPPER FOR NERWORK & PHONE CABLE:
Auto Power Off: 12 seconds after Pass/Fail results
Auto Power Off: 30 minutes in "Tone" mode
Minimum cable length for testing: 0ft
Maximum cable length for testing: 3000ft
Maximum DC cable resistance (Shield + Center Conductor): 100 ohms